Siemens SINUMERIK 840D sl Operation/Programming Manual page 300

ShopTurn Functions
5
5.6 Contour milling
Parameters
T, D, F, S, V See Sec. "Creating program blocks".
Position Select from 8 different positions:
Clamp/release spindle (for End face Y/Peripheral surface Y only)
The function must be set up by the machine manufacturer.
Machining
mode
End face/End face C:
Z0 Reference point in Z direction (abs.)
Z1 Depth with reference to Z0 (abs. or inc.)
DZ Maximum depth infeed (Z direction)
UXY Finishing allowance in plane
Peripheral surface/Peripheral surface C:
Cylinder diameter ¬ (abs.)
X0
Depth with reference to X0 ¬ (abs. or inc.)
X1
DX
Maximum depth infeed (X direction)
UYZ
Finishing allowance in plane
End face Y:
CP Reference point
Z0 Reference point in Z direction (abs.)
Z1 Depth with reference to Z0 (abs. or inc.)
DZ Maximum depth infeed (Z direction)
UXY Finishing allowance in plane
Peripheral surface Y:
C0 Reference point
X0 Reference point in X direction (abs.)
X1 Depth with reference to X0 (abs. or inc.)
DX Maximum depth infeed (X direction)
UYZ Finishing allowance in plane
Retraction If more than one insertion point is necessary, specify the retraction height to which
mode the tool retracts between insertion points:
If there are no islands larger than Z0 (X0) in the pocket area, Z0 + safety clearance
(X0 + safety clearance) can be programmed as the retraction mode.
5-300
Description of finishing the edge
 End face/End face C – Front
 End face/End face C – Rear
 Peripheral surface/Peripheral surface C – Inner
 Peripheral surface/Peripheral surface C – Outer
 End face Y – Front (only when Y axis exists)
 End face Y – Rear (only when Y axis exists)
 Peripheral surface Y – inner (only when Y axis exists)
 Peripheral surface Y – Rear (only when Y axis exists)
Finishing the edge
 To retraction plane
 Z0+safety clearance (for end face/end face C and end face Y only) or
X0+safety clearance (for peripheral surface/peripheral surface C and peripheral
surface Y only)
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
5
Unit
mm
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
♥ Siemens AG, 2005. All rights reserved