Siemens SINUMERIK 840D sl Operation/Programming Manual page 311

08/2005
5
Machining Chamfer
mode
End face/End face C:
Z0 Reference point in Z direction (abs.)
FS Chamfer width; abs
ZFS
Insertion depth tool tip; abs or inc
Peripheral surface/Peripheral surface C:
Cylinder diameter ¬ (abs.)
X0
FS
Chamfer width; abs
ZFS
Insertion depth tool tip; abs or inc
End face Y:
CP Reference point
Z0 Reference point in Z direction (abs.)
FS
Chamfer width; abs
ZFS
Insertion depth tool tip; abs or inc
Peripheral surface Y:
C0 Reference point
X0 Reference point in X direction (abs.)
FS Chamfer width; abs
ZFS
Insertion depth tool tip; abs or inc
Retraction If more than one insertion point is necessary, specify the retraction height to which
mode the tool retracts between insertion points:
If there are no islands larger than Z0 (X0) in the pocket area, Z0 + safety clearance
(X0 + safety clearance) can be programmed as the retraction mode.
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
 To retraction plane
 Z0+safety clearance (for end face/end face C and end face Y only) or
X0+safety clearance (for peripheral surface/peripheral surface C and peripheral
surface Y only)
ShopTurn Functions
5.6 Contour milling
5
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
Degrees
mm
mm
mm
5-311