Plunge-Turning Residual Material - Siemens SINUMERIK 840D sl Operation/Programming Manual

08/2005
5

5.4.10 Plunge-turning residual material

Parameters
T, D, S, V See Sec. "Creating program blocks".
FX Feed in X direction
FZ Feed in Z direction
Machining
type
Stock removal Stock removal direction: Longitudinal or transverse
direction
Machining side Machining side:
For stock removal in longitudinal direction: External or internal
For stock removal in transverse direction: end face or rear side
D Infeed depth for roughing (inc.)
XDA 1. grooving limit tool (inc) – (end face or rear face only)
XDB 2. grooving limit tool (inc) – (end face or rear face only)
U Finishing allowance in X and Z direction (inc) – (roughing only) – (alternative to UX
and UZ)
UX Finishing allowance in X direction (inc) – (roughing only) – (alternative to U)
UZ Finishing allowance in Z direction (inc) – (roughing only) – (alternative to U)
Stock Compensation allowance for contour or not – (finishing only)
allowance
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
The "Plunge-turning residual material" function is used when you want
to machine the material that remained after grooving along the
contour.
During plunge-turning, ShopTurn automatically detects any residual
material and generates an updated blank contour. Material that
remains as part of the finishing allowance is not residual material. The
"Plunge-turning residual material" function allows you to remove
unwanted material with a suitable tool.
The "Plunge-turning residual material" function is a software option.
Press the "Contour turning" and "Plunge-turn. resid." soft keys.
Plunge-turn
resid.
Roughing
Finishing
5.4 Contour turning
Description
ShopTurn Functions
5
Unit
mm/rev
mm/rev
mm
mm
mm
mm
mm
mm
5-233