Siemens SINUMERIK 840D sl Operation/Programming Manual page 238

ShopTurn Functions
5
5.5 Milling
Single position End face/End face C:
The reference point is always the center point of the rectangular pocket.
X0 Reference point in X direction (abs.)
Y0 Reference point in Y direction (abs.)
L0 Reference point on longitudinal polar axis (alternative to X0)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Z1 Pocket depth based on Z0 (abs or inc) – (only for roughing and finishing)
DXY Maximum infeed in the XY plane – (for roughing and finishing only)
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UXY Finishing allowance in the plane (pocket edge) – (for roughing and finishing only)
UZ Finishing allowance in depth (pocket base) – (for roughing and finishing only)
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Single position Peripheral surface/Peripheral surface C:
The reference point is always the center point of the rectangular pocket.
Y0 Reference point in Y direction (abs.)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Cylinder diameter ¬ (abs.)
X0
X1
Pocket depth based on X0 (abs or inc) – (only for roughing and finishing)
DYZ
Maximum infeed in the YZ plane – (for roughing and finishing only)
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm)
DX
Maximum depth infeed (X direction) – (for roughing and finishing only)
UYZ
Finishing allowance in the plane (pocket edge) – (for roughing and finishing only)
UX
Finishing allowance in depth (pocket base) – (for roughing and finishing only)
FS
Chamfer width (inc) (for chamfer only)
ZFS
Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Single position End face Y:
The reference point is always the center point of the rectangular pocket.
CP Positioning angle for machining area
X0 Reference point in X direction (abs.)
Y0 Reference point in Y direction (abs.)
L0 Reference point on longitudinal polar axis (alternative to X0)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Z1 Pocket depth based on Z0 (abs or inc) – (only for roughing and finishing)
DXY Maximum infeed in the XY plane – (for roughing and finishing only)
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UXY Finishing allowance in the plane (pocket edge) – (for roughing and finishing only)
UZ Finishing allowance in depth (pocket base) – (for roughing and finishing only)
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
5-238
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
5
mm
mm
mm
Degrees
mm
mm
mm
%
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
%
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
Degrees
mm
mm
mm
%
mm
mm
mm
mm
mm
♥ Siemens AG, 2005. All rights reserved