Siemens SINUMERIK 840D sl Operation/Programming Manual page 2

SINUMERIK® Documentation
Printing history
Brief details of this edition and previous editions are listed below.
The status of each version is indicated by the code in the "Remarks" columns.
Status code in the "Remarks" column:
A .... New documentation.
B .... Unrevised reprint with new order number
C .... Revised edition with new version code
Edition Order No.
03/2001 6FC5 298-6AD50-0BP0
01/2002 6FC5 298-6AD50-0BP1
06/2003 6FC5 298-6AD50-0BP2
08/2005 6FC5 398-5AP10-0BA0
Trademarks
®
SIMATIC , SIMATIC HMI
trademarks of Siemens AG. The remaining designations found in this publication could be trademarks whose
use by a third party for its own purposes could violate the rights of the owner.
Additional information is available in the Internet at:
http://www.siemens.com/motioncontrol
© Siemens AG 2005
6FC5398-5AP10 - 0BA0
® ®
, SIMATIC NET , SIROTEC
Remarks
A
C
C
C
® ®
, SINUMERIK and SIMODRIVE
Other functions not described in this documentation may be executable in the
.
control This does not, however, represent an obligation to supply such functions
with a new control or when servicing.
We have checked the contents of this manual for agreement with the hardware and
software described. Nevertheless, differences might exist and we cannot, therefore,
guarantee that they are completely identical. The information contained in this
document is, however, reviewed regularly and any necessary changes will be
included in the next edition. Suggestions for improvement are welcome.
Subject to change without prior notice
Siemens Aktiengesellschaft
®
are registered