Siemens SINUMERIK 840D sl Operation/Programming Manual page 320

ShopTurn Functions
5
5.9 Machining with the counterspindle
Complete:
Parkposition WCS: The park position is entered into the workpiece coordinate system
MCS:
of the park position and the angular offset is possible
XP Park position of tool in X direction (abs)
ZP Park position of tool in Z direction (abs)
Gripping:
Rinse chuck Rinse counterspindle chuck or not
S Spindle speed (main spindle and counterspindle)
Direction of Direction of rotation (main spindle and counterspindle):
rotation
α1
Angular offset of counterspindle on gripping
Transfer position (abs.)
Z1
Position at which traversal at reduced feedrate starts (abs or inc)
ZR
Reduced feedrate
FR
Yes:
Fixed stop
No:
Pulling:
Pull blank Yes:
No:
F Feedrate for pulling
Parting cycle Yes:
No:
Rear side:
Work offset Work offset in which the coordinate system, which was shifted according to ZW and
by ZV as well as mirrored in Z, must be saved.
ZnW Machining position for special axis (abs.); machine coordinating system
ZV Workpiece zero offset in Z direction (inc, the sign is also evaluated)
5-320
The park position is entered in the machine coordinate system; the teaching
Direction of rotation clockwise (right)
Direction of rotation counterclockwise (left)
No spindle rotation
The counterspindle comes to a halt a specified distance from the
transfer position Z1 and then traverses at the specified feedrate as far as
the limit stop.
The counterspindle traverses to the transfer position Z1.
Pull blank one blank length (preparation for next
workpiece)
Do not pull blank
The workpiece is parted after it has been pulled out.
No automatic parting.
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
5
mm
mm
rpm
Degrees
mm
mm
mm/min
mm/min
mm
mm
♥ Siemens AG, 2005. All rights reserved