Siemens SINUMERIK 840D sl Operation/Programming Manual page 249

08/2005
5
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Single position End face Y:
The reference point is always the center point of the circular spigot.
CP Positioning angle for machining area
X0 Reference point in X direction (abs.)
Y0 Reference point in Y direction (abs.)
L0 Reference point on longitudinal polar axis (alternative to X0)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Z1 Spigot depth based on Z0 (abs or inc) – (only for roughing and finishing)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UXY Finishing allowance in the plane (spigot edge) – (for roughing and finishing only)
UZ Finishing allowance in depth (spigot base) – (for roughing and finishing only)
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Single position Peripheral surface Y:
The reference point is always the center point of the circular spigot.
C0 Reference point
Y0 Reference point in Y direction (abs.)
Z0 Reference point in Z direction (abs.)
X0 Reference point in X direction (abs.)
X1 Spigot depth based on X0 (abs or inc) – (only for roughing and finishing)
DX Maximum depth infeed (X direction) – (for roughing and finishing only)
UYZ Finishing allowance in the plane (spigot edge) – (for roughing and finishing only)
UX Finishing allowance in depth (spigot base) – (for roughing and finishing only)
FS Chamfer width (inc) (for chamfer only)
Insertion depth of tool tip (abs or inc) -- (for chamfer only)
ZFS
¬
Diameter of finished-part spigot
¬ 1
Diameter of blank spigot (important for determining approach position)
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
ShopTurn Functions
5
5.5 Milling
mm
mm
Degrees
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
5-249