Siemens SINUMERIK 840D sl Operation/Programming Manual page 234

ShopTurn Functions
5
5.4 Contour turning
U1 Compensation allowance in X and Z direction (inc) – (with allowance only)
Positive value: Compensation allowance is not removed
Negative value: Compensation allowance is removed in addition to finishing
allowance
DI Distance after which feed interruption occurs - (only for roughing)
Set machining Limit machining area or not
area limits
XA Limit X (abs) – (with limited machining area only)
XB Limit X (abs or inc) – (with limited machining area only)
ZA Limit Z (abs) – (with limited machining area only)
ZB Limit Z (abs or inc) – (with limited machining area only)
N Number of grooves
5-234
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
5
mm
mm
mm
mm
mm
mm
♥ Siemens AG, 2005. All rights reserved