Siemens SINUMERIK 840D sl Operation/Programming Manual page 92

Machining the Workpiece
3
3.1 Starting/stopping machining
Program execution: Start
Cycle Start
Stopping the program
Cycle Stop
Program: Aborting
Reset
3-92
Example for the program view in "Machine Auto" mode
When you select a program for the first time for execution, that
contains the cycles "Stock removal towards contour" or "Contour
pocket", the individual stock removal steps or solid machining steps
for the contour pocket are calculated automatically. This process may
take several seconds depending on the complexity of the contour.
Press the "Cycle Start" key.
The program is started and executed from the beginning or from the
highlighted program block.
Press the "Cycle Stop" key.
Machining stops immediately, individual blocks do not finish execution.
When it is started again, the machining will resume at the point where
it stopped.
Press the "Reset" key.
Execution of the program is interrupted. When it is started again, it will
execute from the beginning.
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
3
♥ Siemens AG, 2005. All rights reserved