Matrix Position Pattern - Siemens SINUMERIK 840D sl Operation/Programming Manual

08/2005
5
Peripheral surface Y:
X0 X coordinate of the reference point (abs.)
C0 Reference point
Y0 Y coordinate of the reference point – first position (abs.)
Z0 Z coordinate of the reference point – first position (abs.)
α0
Angle of rotation of line with reference to Y axis
Positive angle: Line is rotated counterclockwise.
Negative angle: Line is rotated clockwise.
L Position spacing
N Number of positions

5.2.10 Matrix position pattern

Parameters
Position Select from 8 different positions:








♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
The "Matrix position pattern" function is used to program any number
of positions that lie equidistant on several parallel straight lines.
If you want to program a rhombus-shaped matrix, enter the angle
or αY.
Press the "Drilling", "Positions" and "Line/Matrix/Box" soft keys.
Positions >
Select the "Matrix" position pattern in the "Line/Matrix/Box"
parameter field.
End face/End face C – Front
End face/End face C – Rear
Peripheral surface/Peripheral surface C – Inner
Peripheral surface/Peripheral surface C – Outer
End face Y – Front (only when Y axis exists)
End face Y – Rear (only when Y axis exists)
Peripheral surface Y – inner (only when Y axis exists)
Peripheral surface Y – Rear (only when Y axis exists)
Description
ShopTurn Functions
5
5.2 Drilling
mm
Degrees
mm
mm
Degrees
mm
αX
Unit
5-183