Siemens SINUMERIK 840D sl Operation/Programming Manual page 37

08/2005
1
Process plan
Programming graphics
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
The process plan provides an overview of the separate machining
steps of a program.
Process plan
You can move between the program blocks in the process plan using
the "Cursor up" and "Cursor down" keys.
Use the "Help" key to switch between the process plan and the
programming graphics.
The programming graphics show the contour of the workpiece as a
dynamic graphic with dashed lines. The program block selected in the
process plan is color-highlighted in the programming graphics.
Programming graphics
Introduction
1.3 Operator interface
1
1-37