Siemens SINUMERIK 840D sl Operation/Programming Manual page 286

ShopTurn Functions
5
5.6 Contour milling
Radius Input defining which side of the contour the milling cutter machines in the
compensation programmed direction:
End face/End face C:
Z0 Reference point in Z direction (abs.)
Z1 Depth based on Z0 (abs or inc) – (only for roughing and finishing)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UZ Finishing allowance in depth (for roughing only)
UXY Finishing allowance in the plane (only for roughing and to the left of the contour)
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Peripheral surface/Peripheral surface C:
Slot wall offset Activate slot wall offset
D Offset to programmed path (only with activated slot wall offset)
Cylinder diameter ¬ (abs.)
X0
Depth based on Z0 ¬ (abs or inc) – (only for roughing and finishing)
X1
DX
Maximum depth infeed (X direction) – (for roughing and finishing only)
UX
Finishing allowance in depth (for roughing only)
UYZ
Finishing allowance in the plane (only for roughing and to the left of the contour)
FS
Chamfer width (inc) (for chamfer only)
ZFS
Insertion depth of tool tip (abs or inc) -- (for chamfer only)
End face Y:
CP Reference point
Z0 Reference point in Z direction (abs.)
Z1 Depth based on Z0 (abs or inc) – (only for roughing and finishing)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UZ Finishing allowance in depth (for roughing only)
UXY Finishing allowance in the plane (only for roughing and to the left of the contour)
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Peripheral surface Y:
C0 Reference point
X0 Reference point in X direction (abs.)
X1 Depth based on X0 (abs or inc) – (only for roughing and finishing)
DX Maximum depth infeed (X direction) – (for roughing and finishing only)
Finishing allowance in depth (for roughing only)
UX Finishing allowance in the plane (only for roughing and to the left of the contour)
UYZ Chamfer width (inc) (for chamfer only)
FS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
ZFS
5-286
Machining to the right of the contour
Machining to the left of the contour
Machining along the center path
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
5
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
♥ Siemens AG, 2005. All rights reserved