Siemens SINUMERIK 840D sl Operation/Programming Manual page 98

Machining the Workpiece
3
3.5 Starting the machining at a specific point in the program
Selecting the ShopTurn
cycle
Cycle Start
Cycle Start
Reset
Selecting the misc.
ShopTurn block or G-
code block
3-98
Line:
Type:
Search target: Point in the program at which machining is to start
Load a program in "Machine Auto" mode (see Sec.
"Starting/Stopping Machining").
Position the cursor on the desired target block.
Press the "Block search" and "Start Search Run" softkeys.
Start
Search Run
Where chained program blocks have several technology blocks,
select the desired technology block in the "Search run" window.
The prompt does not appear in the case of single program blocks.
Press the "Accept" softkey.
For chained program blocks, enter the number for the desired
starting position.
The prompt does not appear in the case of single program blocks.
During the block search run on the position pattern, the skipped
positions are not counted.
Press the "Accept" softkey.
Press the "Cycle Start" key.
ShopTurn carries out all necessary pre-settings.
Press the "Cycle Start" key again.
The new starting position is approached. The workpiece is then
machined from the beginning of the target block.
You can abort the search by pressing the "Reset" key.
Position cursor on target block
Load a program in "Machine Auto" mode (see Sec.
"Starting/stopping machining").
Position the cursor on the desired target block.
Parameter is given by ShopTurn
" " Search target is ignored on this level
N no. Block number
Marker Jump marker
Text Character string
Sub-r. Subroutine call
Line Line number
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
3
♥ Siemens AG, 2005. All rights reserved