Mdi - Siemens SINUMERIK 840D sl Operation/Programming Manual

Setting Up the Machine
2

2.9 MDI

2.9

MDI

MDI
Cycle Start
Delete MDI
Progr.
2-86
In "MDI" mode (Manual Data Automatic mode), you can input G-code
commands block-by-block and immediately execute them for setting
up the machine.
When executing the G-code commands, you can control the sequence
as follows:
Executing the program block-by-block
Program:Testing
Setting the test-run feedrate
(see Sec. "Machining the workpiece")
Press the "MDI" key.
The MDI editor opens.
MDI
Input the desired G-code commands using the operator's
keyboard.
Press the "Cycle Start" key.
The control executes the input blocks.
Depending on the machine manufacturer's setting, the program
created in MDA mode is automatically deleted after the complete
execution, or you can delete it using the "Delete MDI Progr." softkey.
Please also refer to the machine manufacturer's instructions.
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
2
♥ Siemens AG, 2005. All rights reserved