ABB ACS800 Series Firmware Manual page 132

120
No. Name/Value
65.07 WEB THICKNESS
0.01...9999.00 mm
0.01...9999.00 mils
65.08 COUNT UP ENABLE
NO
YES
65.09 COUNT DOWN ENABLE
NO
YES
65.10 MAN DIA SLOW RATE
0.1...1000.0 mm/s
0.1...1000.0 in/s
65.11 MAN DIA FAST RATE
0.1...1000.0 mm/s
0.1...1000.0 in/s
65.12 MAN DIA INC
NOT SEL
DI2
DI3
DI4
DI5
DI6
DI7
DI8
DI9
DI10
DI11
DI12
FIELDBUS
65.13 MAN DIA DEC
NOT SEL
DI2
DI3
Actual signals and parameters
Description
Set to a value larger than the thickest material that will be run through
the machine. If the value entered is too small, the calculator can not
keep up with the actual rate of change on the machine.
For a wire winding application enter a value equivalent to the wire's
diameter divided by the number of turns needed to complete one full
width of the spool.
Setting range.
Allows the diameter calculator to increase the diameter value.
Actual calculated diameter can not increase.
Actual calculated diameter can increase.
Allows the diameter calculator to decrease the diameter value.
Actual calculated diameter can not decrease.
Actual calculated diameter can decrease.
Slow rate at which the calculated diameter will change if
DIA DEC or 65.12 MAN DIA INC is active. After 3 seconds, the rate
changes to 65.11 MAN DIA FAST RATE.
Setting range.
Fast rate at which the calculated diameter will change if
DIA DEC or 65.12 MAN DIA INC is active.
Setting range.
Sets or selects the activation signal source for manually increasing the
calculated diameter.
Not selected.
Digital input DI2 = 1 increases the calculated diameter at a rate of
65.10 MAN DIA SLOW RATE or
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2. Instead of a digital input, the command comes from
06.03 DATASET 1 WORD 3 bit 09. See chapter
Sets or selects the activation signal source for manually decreasing
the calculated diameter.
Not selected.
Digital input DI2 = 1 decreases the calculated diameter at a rate of
65.10 MAN DIA SLOW RATE or
See selection DI2.
65.13
65.13
65.11 MAN DIA FAST RATE.
Fieldbus control.
65.11 MAN DIA FAST RATE.
FbEq
100 = 1 mm
100 = 1 mils
0
65535
0
65535
MAN
10 = 1 mm/s
10 = 1 in/s
MAN
10 = 1 mm/s
10 = 1 in/s
1
2
3
4
5
6
7
8
9
10
11
12
13
1
2
3