Dataset Input Sel - ABB ACS800 Series Firmware Manual

No. Name/Value
85.08 CONSTANT8
-8388608 to 8388607
85.09 CONSTANT9
-8388608 to 8388607
85.10 CONSTANT10
-8388608 to 8388607
85.11 STRING1
MESSAGE1
85.12 STRING2
MESSAGE2
85.13 STRING3
MESSAGE3
85.14 STRING4
MESSAGE4
85.15 STRING5
MESSAGE5

90 DATASET INPUT SEL

90.01 DATA 1 WORD 1
0...10000
90.02 DATA 1 WORD 2
0...10000
90.04 DATA 3 WORD 1
0...10000
90.05 DATA 3 WORD 2
0...10000
90.06 DATA 3 WORD 3
0...10000
90.08 DATA 5 WORD 2
Description
Sets a constant for the Adaptive Program.
Integer value.
Sets a constant for the Adaptive Program.
Integer value.
Sets a constant for the Adaptive Program.
Integer value.
Stores a message to be used in the Adaptive Program (EVENT block).
Message.
Stores a message to be used in the Adaptive Program (EVENT block).
Message.
Stores a message to be used in the Adaptive Program (EVENT block).
Message.
Stores a message to be used in the Adaptive Program (EVENT block).
Message.
Stores a message to be used in the Adaptive Program (EVENT block).
Message.
Addresses of the parameters into which the received fieldbus data are
written. Refer to Table 2 on page
Pointer for the parameter to which the value of the fieldbus is written.
Note: A connection for the fieldbus main command word is
hardcoded in the program. If a signal other than this is sent to this
location, ensure that no parameters are set to FIELDBUS (that use
06.01 DATASET 1 WORD 1).
Setting range.
Pointer for the parameter to which the value of the fieldbus is written.
Note: A connection for the external reference is hardcoded in the
program. If a signal other than this is sent to this location, ensure that
11.03 EXT1 REF SELECT is not set to FIELDBUS.
Setting range.
Pointer for the parameter to which the value of the fieldbus is written.
Note: A connection for the web tension setpoint is hardcoded in the
program. If a signal other than this is sent to this location, ensure that
neither 62.10 DANCER LOAD SETPT nor
SETPOINT are set to FIELDBUS.
Setting range.
Pointer for the parameter to which the value of the fieldbus is written.
Note: A connection for tension taper is hardcoded in the program. If
a signal other than this is sent to this location, ensure that TAPER REF
SELECT (62.12 or 63.12) is not set to FIELDBUS.
Setting range.
Pointer for the parameter to which the value of the fieldbus is written.
Note: A connection for the core speed match value is hardcoded in
the program. If a signal other than this is sent to this location, ensure
that 61.01 SPD MTCH REF SEL is not set to FIELDBUS.
Setting range.
Pointer for the parameter to which the value of the fieldbus is written.
147 for more default information.
63.10 TENSION
Actual signals and parameters
129
FbEq
1 = 1
1 = 1
1 = 1
-
-
-
-
-
1 = 1
1 = 1
1 = 1
1 = 1
1 = 1