User Macros - ABB ACS800 Series Firmware Manual

62

User macros

In addition to the standard application macros, it is possible to create two user
macros. The User macro allows the user to save the parameter settings including
Group 99, and the results of the motor identification into the permanent memory, and
recall the data at a later time. The panel reference is also saved.
To create User macro 1:
• Adjust the parameters. Perform the motor identification if not performed yet.
• Save the parameter settings and the results of the motor identification by
changing
storing takes 20 s to 1 min.
Note: If user macro save function is executed several times, drive memory fills up
and file compression starts. File compression can last up to 10 minutes. Macro
saving will be completed after the file compression. (Operation is indicated on the
last row of the control panel display by blinking dots).
To recall the User macro:
• Change
• Press ENTER to load.
The User macro can also be switched via digital inputs (see
CHG).
Note: User macro load restores also the motor settings in group
DATA
to the motor used.
Example: The user can switch the drive between two motors without having to
adjust the motor parameters and to repeat the motor identification every time the
motor is changed. The user needs only to adjust the settings and perform the motor
identification once for both motors and then to save the data as two user macros.
When the motor is changed, only the corresponding User macro needs to be loaded,
and the drive is ready to operate.
Application macros
99.02 APPLICATION MACRO to USER 1 SAVE (press ENTER). The
99.02 APPLICATION MACRO to USER 1 LOAD.
and the results of the motor identification. Check that the settings correspond
16.05 USER MACRO IO
99 START-UP