Core Speed Match - ABB ACS800 Series Firmware Manual

No. Name/Value
60.04 WEB LOSS DELAY
0...100.0 s
60.05 WINDING MODE
OVER
UNDER
DI2 – UNDER
DI3 – UNDER
DI4 – UNDER
DI5 – UNDER
DI6 – UNDER
DI7 – UNDER
DI8 – UNDER
DI9 – UNDER
DI10 – UNDER
DI11 – UNDER
DI12 – UNDER
FBUS – UNDER

61 CORE SPEED MATCH

61.01 SPD MTCH REF SEL
NOT SEL
Description
Time after detection occurs before a digital output
STATUS BITS bit 00) is set. See chapter
Web Loss is calculated three different ways:
DANCER CONTROL
Trip occurs if Dancer moves to its maximum position signifying loss of
tension on the web. This would be a low value at the input to the drive.
TENSION CONTROL
Trip occurs if actual tension drops below trip percentage
WEBLOSS TRIP) of 63.14
Control when loadcells are used for actual tension feedback.
TORQUE CONTROL
Trip occurs if the actual torque % drops below trip percentage
WEBLOSS TRIP) of the available motor torque. Select Torque Control
when actual tension feedback is not available.
Setting range.
When setting up the drive, keep the following in mind. The software
assumes the motor is set up as one of the following:
A
The program defaults the following parameters based on the above
assumption:
If the web needs to go in the opposite direction, change DIRECTION.
If the drive is an Underwind, change
dancer/loadcell is on the opposite side of web flow with respect to the
drive, change REVERSE REG OUT (62.08...63.08).
Overwind is selected.
Underwind is selected.
Digital input DI2 = 1 selects Underwind.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2 - UNDER.
See selection DI2. Instead of a digital input, the selection comes from
06.03 DATASET 1 WORD 3 bit 14. See chapter
Used to match the speed of a core to line speed in automatic roll
change machines.
Selects the signal source for the reference value for the speed match
trim amount.
Speed matching function is not used.
(03.15
Fieldbus control.
MAXIMUM TENSION. Select Tension
60.05 WINDING MODE. If the
Fieldbus
Actual signals and parameters
101
FbEq
PACK
(60.03
(60.03
10 = 1 s
B
1
2
3
4
5
6
7
8
9
10
11
12
13
14
control.
1