Torque Mem Ctrl - ABB ACS800 Series Firmware Manual

122
No. Name/Value
AI6
65.22 DIA HOLD PTR
-255.255.31...+255.255.31
/ C.-32768 ...C.32767

66 TORQUE MEM CTRL

66.01 TORQUE MEM SAMPLE
NOT SEL
DI2
DI3
DI4
DI5
DI6
DI7
DI8
DI9
DI10
DI11
DI12
FIELDBUS
Actual signals and parameters
Description
Uses a sensor on analog input AI6 (voltage or current).
This parameter defines the source to hold the diameter calculation. An
input of binary 1 will hold the calculation.
Parameter index or a constant value. See
information on the difference.
Torque memory control and setup. Typically used on turret
Start of
index
Sample torque
for torque mem
Torque mem
enable
Notes:
Mechanical operations:
ACS800 controlled operations
Tension/Dancer MUST be enabled during cycle.
Selects the activation signal source for torque sampling.
Torque memory is not used.
Digital input DI2 = 1 memorizes the actual motor torque.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2.
See selection DI2. Instead of a digital input, the command comes from
06.03 DATASET 1 WORD 3 bit 11. See chapter
10.05 EXT1 STRT PTR for
Torque sample OFF
Finishing roll
Torque mem OFF
is isolated
Tension OFF
Stop winder
Remove finished roll
Reset diameter
Knife
cut
Time Delay
66.03
Torque Boost
after time delay
Fieldbus
FbEq
5
-
winders.
Time
1
2
3
4
5
6
7
8
9
10
11
12
13
control.