External Control; Settings - ABB ACS800 Series Firmware Manual

24

External control

When the drive is in external control, the commands are given through the control
terminal block on the standard I/O board (digital and analog inputs), optional I/O
extension modules and/or CH0 Fieldbus Adapter. In addition, it is also possible to
set the control panel as the source for the external control.
External control is indicated by a blank on the panel display or with an R in those
special cases when the panel is defined as a source for external control.
1
External Control through the Input/
Output terminals, or through the
fieldbus interfaces

Settings

Panel Key
LOC/REM
Parameter
10.01
10.02
11.03
Group
Program features
->1242 rpm I
98 OPTION MODULES
1 R ->1242 rpm
External Control by control panel
Additional Information
Selection between local and external control
Start and stop source for EXT1
Direction source for EXT1
Reference source for EXT1
Activation of the optional I/O and serial communication
I