Siemens SINAMICS S120 Manual page 678

Cabinet design and EMC Booksize
12.4 Arrangement of components and equipment
Table 12- 3 Comparison of the connection versions
Var. Module width Installa-
[mm] tion
1 50 ... 100 Right
2 50 ... 100 Right
3 50 ... 100 Left
4 150 Right
5 150 ... 300 Left
6 200 ... 300 Right
Connections as cross-sectional drawings (view from below)
Note
The different connection versions of the DC-link adapter are shown in the following cross-
sectional drawings. Special features are highlighted in bold in the table above.
Variant 1: Module width 50-100 mm, connected to the drive line-up from the right, standard DC-link
busbar
①
②
③
④
⑤
Figure 12-6
678
Current- DC-link
carrying adapter
capacity of 6SL3162-...
the
DC-link bus-
bar [A]
≤ 100 2BM01-0AA0 Standard
≤ 150 2BM10-0AA0 Reinforced 2 screws
≤ 100 2BM01-0AA0 Standard
≤ 150 2BM01-0AA0 Standard
≤ 150 2BM01-0AA0 Standard
≤ 200 2BM01-0AA0 Standard
DC-link adapter 6SL3162-2BM01-0AA0 (4 hole)
Standard DC-link busbar (4 mm)
Connecting the DC-link adapter to the module using 2 M4x20 screws
Connecting the DC-link busbar to the module using 2 M4x16 screws
DC-link bridge
Variant 1 (representation from below)
DC-link Fastening of the
busbar DC-link adapter
to two DC-link
busbars
2 screws
2 screws
2 screws
2 screws
4 screws
Manual, (GH2), 07/2016, 6SL3097-4AC00-0BP8
Screws Washers
M4x20 No
M4x20 No
M4x16 No
M4x20 No
M4x20 Yes
M4x20 No
Booksize Power Units