Komatsu PC200-8M0 Shop Manual page 337

100 Standard service value table
Standard value table for chassis related parts
Cate-
Item
gory
Travel speed
(actual running)
Travel deviation
Machine drift on a
slope
Leakage from travel
motor
Whole work
equipment
Boom cylinder
Arm cylinder
Bucket cylinder
PC200, 200LC, 220, 220LC-8M0
Applicable model
Measurement condition
• Hydraulic oil
temperature: Within
operating range
• Engine running at
high idle
• Working mode: P
mode
• Flat ground
• Time required to
travel 20 m after
running up 10 m
• For measuring
posture, see Travel
2
• Hydraulic oil temperature: Within
operating range
• Engine at high idle
• Working mode: P mode
• Travel speed: Lo
• Solid and flat ground
• Travel deviation (x) in travel of 20 m
after running up 10 m
• For measuring posture, see Travel
2 and 3
• Hydraulic oil temperature: Within
operating range
• Engine stopped
• Parking machine on slope of 12°
with sprocket facing upslope
• Sliding distance for 5 minutes
• For measuring posture, see Travel
4
• Hydraulic oil temperature: Within
operating range
• Engine at high idle
• Traveling with sprocket locked
• Leakage in 1 minute during travel
relief
• Hydraulic oil temperature: Within
operating range
• Flat and level ground
• Fill bucket with dirt or rated load
3
(0.8m : 1,440kg)
• Boom horizontal, arm fully retracted,
bucket cylinder fully extended
• Engine stopped
• Work equipment control lever in
NEUTRAL position
• Fall amount for 15 minutes as
measured every 5 minutes starting
immediately after initial setting
• For measuring posture, see Work
equipment 1
Standard value for new
Unit
Lo sec. 24 (+1.7/-3.1)
Mi sec.
Hi sec.
mm
mm
l/min
mm
mm
mm
mm
SEN06125-00
PC200, 200LC-8M0
Judgement criteria
machine
20.9 to 26.9
17 ± 2.5 14.5 to 20.5
13 ± 1.0 12.0 to 15.0
Max. 150 Max. 250
0
13.6
Max. 644 Max. 966
Max. 19 Max. 29
Max. 184 Max. 276
Max. 42 Max. 63
0
27.2
7
20-100