Komatsu PC200-8M0 Shop Manual page 460

SEN06128-00
[F6]: Validates the selection and returns
q
the display to the default screen
a When an attachment is installed, if this
setting is not configured correctly, the set-
ting of attachment in the operator mode
cannot be performed. As a result, the
attachment may not work normally or the
hydraulic components may be damaged.
Default (Camera)
Use the menu of "Default" to check or change vari-
ous settings of the machine monitor and machine.
Use the sub menu of "Camera" to configure camera
setting when the camera is installed or removed.
1. Selecting the menu
Select "Default" on the "Service Menu" screen.
40
30-102
102 Testing and adjusting, Part 2
Special functions of machine monitor
2. Selecting sub menu
After the "Default" screen is displayed, select
"Camera" using the function switch or numeral
input switches.
a Select this sub menu as in the case of
selecting a menu on the "Service Menu"
screen.
3. Selection of camera setting
After the "Camera" screen for setting is dis-
played, select the setting by using the function
switches.
q Without Attachment:
selected.
With Attachment:
q
camera is displayed in original position (as
in mirror, used for back monitor)
[ ]: Image of connected camera is dis-
q
played in reverse position (as seen
directly, when used as front or side moni-
tor)
[R]: Image of connected camera is dis-
q
played in original position (as in mirror,
used for back monitor)
[F3]: Moves to lower item
q
q [F4]: Moves to upper item
q [F5]: Cancels the setting before validation
and returns the display to the Default
screen
q [F6]: Validates the selection made in each
step
a Camera 1 does not provide switching
between [ ] and [R] .
a After entering the setting of each column
by using [F6], return to the "Default"
screen by using [F5], and the setting is
effective.
a If a camera is connected but not config-
ured normally by using this function, the
icon of camera is not displayed above [F3]
in the operator mode. Accordingly, the
image of the camera cannot be seen.
PC200, 200LC, 220, 220LC-8M0
Camera is not
Image of connected