Komatsu PC200-8M0 Shop Manual page 454

SEN06128-00
Maintenance Mode Setting
The actuating condition of the maintenance
reminder function in the operation mode can be set
and changed by using this menu.
To enable or disable the function
q
q To change set replacement interval (by item)
q To initialize all set replacement intervals
1. Selecting the menu
Select "Maintenance Mode Setting" on the
"Service Menu" screen.
2. Selecting sub menu
After the "Maintenance Mode Setting" screen is
displayed, select an item to change the setting
with the function switches or the numeral input
switches.
q [F1]: Moves to the next page (screen)
q [F2]: Moves to the previous page (screen)
[F3]: Moves to lower item
q
q [F4]: Moves to upper item
q [F5]: Returns the display to the service
menu screen
q [F6]: Validates the selection
a You may enter a 2-digit code by using the
numeral input switches to select the item
of that code and enter it by using [F6].
34
30-102
102 Testing and adjusting, Part 2
Special functions of machine monitor
a The following items can be selected on the
"Maintenance Mode Setting" screen.
00 Maintenance Mode Change
49 Air Cleaner cleaning / Change Interval
01 Engine Oil Change Interval
02 Eng Oil Filter Change Interval
03 Fuel Main Filter Change Interval
41 Fuel Pre Filter Change Interval
04 Hyd. oil filter change interval
05 H/tank breather change interval
07 Damper Case Service Interval
08 Final Drive Oil Change Interval
09 S/Machinery oil change interval
10 Hydraulic Oil Change Interval
99 All Default Value
3. Contents of "Maintenance Mode Change"
After selecting "Maintenance Mode Change"
and the screen is displayed, select the desired
setting with the function switches.
q ON: Functions of all maintenance items
are set effective in operator mode
q OFF: Maintenance reminder functions of
all maintenance items are disabled in
operator mode
q [F3]: Moves to lower item
q [F4]: Moves to upper item
q [F5]: Cancels selection and return to the
"Maintenance Mode Change" screen
q [F6]: Enters selection and return to the
"Maintenance Mode Change" screen
a Even if ON/OFF of each item has been
set, if the above setting is changed, it
overrides the individual setting.
PC200, 200LC, 220, 220LC-8M0