Komatsu PC200-8M0 Shop Manual page 431

102 Testing and adjusting, Part 2
Special functions of machine monitor
Operation of windshield wiper
While the ordinary screen is displayed, if the wiper
switch is pressed, large wiper monitor (a) is dis-
played for 2 seconds and the wiper starts or stops.
a The window washer does not operate if the
window limit switch is "ON".
a The
wiper setting
between [INT] o [ON] o [OFF] o [INT] every
time you press the switch.
a When the wiper is set to INT or ON, large mon-
itor (a) is displayed and the display of wiper
monitor (b) is changed at the same time.
a If the wiper is set to OFF, large monitor (a) is
not displayed and the wiper monitor disap-
pears.
Operation of window washer
While the ordinary screen is displayed, if the win-
dow washer switch is pressed, the washer fluid is
splashed only while the switch is held down.
a Even if the window washer switch is pressed,
the screen display does not change.
Operation of air conditioner/heater
While the standard screen is displayed, if the air
conditioner switch is pressed, "Air-conditioner Set-
ting" screen is displayed.
a While "Air-conditioner Setting" screen is dis-
played, if you do not touch any switch for 5
seconds, the screen changes to the standard
screen.
PC200, 200LC, 220, 220LC-8M0
changes sequentially
Operation to display camera mode (if camera is
installed)
If [F3] is pressed, the multi-display changes to the
camera image (Set the connection of the camera in
the service mode).
a Up to two cameras can be connected. When
the camera mode is selected, however, only
the image of camera 1 is always displayed at
first.
a If any caution is issued with the display panel
in the camera mode, the corresponding cau-
tion monitor is displayed at the left top of the
screen (excluding the low hydraulic oil temper-
ature caution monitor).
SEN06128-00
11
30-102