200 Foreword and general information
Method of disconnecting and connecting of push-pull type
Type 3
Disconnection
1.
While holding the fitting, push body (9) in
straight until sliding prevention ring (8) hits
contact surface (b) at the hexagonal portion on
the male side. (Fig. 10)
2.
While keeping the condition of Step 1, push
cover (10) straight until it hits contact surface
(b) of the hexagonal portion on the male side.
(Fig. 11)
3.
While keeping the conditions of Steps 1 and 2,
pull out whole body (9) to disconnect it. (Fig.
12)
PC200, 200LC, 220, 220LC-8M0
Connection
1.
While holding the fitting, push body (9) in
straight until sliding prevention ring (8) hits
contact surface (a) at the hexagonal portion on
the male side to connect them. (Fig. 13)
SEN06112-00
19
00-200