Siemens SINUMERIK 840D sl Function Manual page 244

Data Description
8.1 Machine data for SINUMERIK 840D sl
10386
MD number
Default value: 0
Change becomes effective after: Power ON
Data type: DWORD
Significance:
Special cases, errors,...
10387
MD number
Default value: 0
Change becomes effective after: Power ON
Data type: DWORD
Significance:
Special cases, errors,...
10388
MD number
Default value: 0
Change becomes effective after: Power ON
Data type: DWORD
Significance:
Special cases, errors,...
8-244
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
$MN_PROFISAFE_IN_ADDRESS[n]: 0 ... 15
PROFIsafe address of an input module
Min. input limit: 0
Protection level: 7/2
PROFIsafe target address of an input module
Format: 0s 0x aaaa
s: Bus segment (5 = DP connection on the PLC side)
x: Sub-slot address
Value range: 0...1
x = 0 addresses the F net data signals 1...32
x = 1 addresses the F net data signals 33...64
aaaa: Hexadecimal PROFIsafe address of the F module
$MN_PROFISAFE_OUT_ADDRESS[n]: 0 ... 15
PROFIsafe address of a PROFIsafe output module
Min. input limit: 0
Protection level: 7/2
PROFIsafe target address of an output module
Format: 0s 0x aaaa
s: Bus segment (5 = DP connection on the PLC side
x: Sub-slot address
Value range: 0...1
x = 0 addresses the F net data signals 1...32
x = 1 addresses the F net data signals 33...64
aaaa: Hexadecimal PROFIsafe address of the F module
$MN_PROFISAFE_IN_ASSIGN[n]: 0 ... 15
Input assignment, $A_INSE to PROFIsafe module
Min. input limit: 0
Protective stage: 7/2
Assignment between an ext. SPL interface $A_INSE and a PROFIsafe input module.
The three lower positions indicate the least significant $A_INSE variable to be supplied.
The three upper positions indicate the most significant $A_INSE variable to be supplied.
Example:
PROFISAFE_IN_ASSIGN[0] = 4001:
The system variables $A_INSE[1...4] are supplied with the state of the input terminals of
the PROFIsafe module that was defined in MD PROFISAFE_IN_ADDRESS[0].
Max. input limit: 0x0501FFFF
Units: –
Max. input limit: 0x0501FFFF
Units: –
Max. input limit: 64064
Units: –
© Siemens AG, 2006. All rights reserved
03.06