Siemens SINUMERIK 840D sl Function Manual page 469

03.06
Remedy
N30620 (F, A)
Response:
Acknowledgement
Explanation
Remedy
Response:
Acknowledgement for F IMMEDIATELY (POWER ON)
Response:
Acknowledgement for A NONE
© Siemens AG, 2006. All rights reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
Re fault value = 1 to 999:
– Check the crosswise compared data that resulted in a STOP F.
– Carry-out a POWER ON (power off/on) for all components.
– Upgrade the Motor Module software.
– Upgrade the Control Unit software.
Re fault value = 1000:
– Check the wiring of the safety-relevant inputs (SGE) on the Control
Unit (contact problems).
Re fault value = 1001, 1002:
– Carry-out a POWER ON (power off/on) for all components.
– Upgrade the Motor Module software.
– Upgrade the Control Unit software.
Re fault value = 2000, 2001:
– Check the tolerance time SGE changeover and if required, increase
the value (p9650, p9850).
– Check the wiring of the safety-relevant inputs (SGE) (contact
problems).
– Replace the Motor Module involved.
SI MM: Safe standstill active
NONE
NONE
The "safe standstill" function was selected on the Motor Module (MM)
and is active.
Note:
This message does not result in a safety stop response.
None necessary.
OFF2
NONE
10.3 Safety messages for SINAMICS S120
Diagnostics
10-469