Conventional Acceptance Test - Siemens SINUMERIK 840D sl Function Manual

Commissioning
9.5 Acceptance test
Table 9-1 Scope of the acceptance test depending on specific measures
Measure
Function expanded
(e.g. additional actua-
tor, additional SG
stage)
Data transferred to
additional machines
with series commis-
sioning
The acceptance report is included as a Word file in the toolbox supplied and is
made up of the following parts:
S System description
S Description of the safety functions
S Test of safety functions
9.5.2

Conventional acceptance test

Note
The acceptance test is used to check that the safety functions have been correctly
parameterized. The measured values (e.g. distance, time) and the system
behavior determined (e.g. initiating a specific stop) when carrying-out the
acceptance test are used to check the plausibility of the configured safety
functions. Using the acceptance test, potential configuring errors are to be
identified and the correct configuring documented.
Procedure of the conventional acceptance test
Safety function
Forced checking proce-
dure of the shutdown
paths
9-358
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
Documentation Function test
Part 1
Supplement, SI Yes with note
functions per if relevant - limited
axis or function to adapted parts
table
Possibly sup- Yes with note
plement, ma-
chine descrip-
tion (check the
SW version)
Test initiated by
A test stop is initiated,
e.g. by reducing the test
stop time or a separate
key
Function test
Part 2
Partial
test of possible
additional limit val-
ues
No
if data are not
identical
Function checked us-
ing
Alarm log
Diagnostics display
Servo trace SGE/SGA
© Siemens AG, 2006. All rights reserved
03.06
Report
completion
Supplement,
possibly new
checksums and
counter-signature
No
No, if identical
data (check the
checksums)
Represented using
27002 axis
Test stop running
C01798 test stop run-
ning
Diagnostics screen SI
status
De-coded using servo
trace bit graphics