Siemens SINUMERIK 840D sl Function Manual page 304
Sinumerik safety integrated
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Data Description
8.2 Parameters for SINAMICS S120
p9761
SI password input
Enters the Safety Integrated password. It is not permissible to change Safety
Integrated parameter settings until the Safety Integrated password has been
entered.
Units:
Default value:
–
0000 hex
p9762
SI password, new
Enters a new Safety Integrated password. If the Safety Integrated password is
changed it must be acknowledged in the following parameter:
See also: p9763
Units:
Default value:
–
0000 hex
p9763
SI password acknowledgment
Acknowledges the new Safety Integrated password. The new password en-
tered into p9762 must be re-entered in order to acknowledge. After successfully
acknowledged, the new Safety Integrated password is set with
p9762=p9763=0.
See also: p9762
Units:
Default value:
–
0000 hex
r9770[0...2]
SI version, safety-relevant functions integrated in the drive (Control Unit)
Displays the Safety Integrated version on the Control Unit.
Index 0: Safety Version (major release)
Index 1: Safety Version (minor release)
Index 2: Safety Version (baselevel or patch)
Example:
r9770[0]=2, r9770[1]=3, r9770[2]=1––> Safety Version V02.03.01
Units:
Default value:
–
–
r9771
SI common functions (Control Unit)
Displays the Safety Integrated monitoring functions supported on the Control
Unit and Motor Module.
The Control Unit determines this display.
Bit 0: SH supported via terminal
Bit 1: SBC supported
Bit 2: SI motion supported
Units:
Default value:
–
–
8-304
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
Minimum value:
Maximum value:
0000 hex
FFFF FFFF hex
Minimum value:
Maximum value:
0000 hex
FFFF FFFF hex
Minimum value:
Maximum value:
0000 hex
FFFF FFFF hex
Minimum value:
Maximum value:
–
–
Minimum value:
Maximum value:
–
–
Checksum:
Protection level:
No
3
Data type:
Effective:
U32
Immediately
Checksum:
Protection level:
No
3
Data type:
Effective:
U32
Immediately
Checksum:
Protection level:
No
3
Data type:
Effective:
U32
Immediately
Checksum:
Protection level:
No
3
Data type:
Effective:
–
U16
Checksum:
Protection level:
No
3
Data type:
Effective:
–
U32
© Siemens AG, 2006. All rights reserved
03.06
Advertisement
Chapters
Table of Contents
