Siemens SINUMERIK 840D sl Function Manual page 48

Safety Functions Integrated in the Drive
4.1 General information about SINAMICS Safety Integrated
– p0010 = 95 commissioning mode (see Section 4.4 "Commissioning the func-
tions SH and SBC")
– p9761 = Enter "old safety password"
– p9762 = Enter "new password"
– p9763 = Confirm "new password"
– The new and confirmed safety password is valid immediately.
If you need to change safety parameters but you do not know the safety password,
proceed as follows:
1. Restore the factory setting of the complete drive unit (Control Unit with all con-
nected drives/components) (see SINUMERIK 840D sl/SINAMICS S120 Com-
missioning Manual)
2. Recommission the drive unit and drives
3. Recommission Safety Integrated
Parameter overview (see Subsection 8.2.2 "Description of the parameters")
S p9761
S p9762
S p9763
4-48
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
"Enter SI password"
"New SI password"
"Confirm SI password"
© Siemens AG, 2006. All rights reserved
03.06