Siemens SINUMERIK 840D sl Function Manual page 246

Data Description
8.1 Machine data for SINUMERIK 840D sl
13300
MD number
Default value: 0xFFFFFFFF
Change becomes effective after: Power ON
Data type: DWORD
Significance:
corresponds with...
Additional references
8-246
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
$MN_PROFISAFE_IN_FIL TER
F useful (net) data filter IN
Min. input limit: –
Protection level: 7/2
Filter between F net (useful) data and $A_INSE variables
Machine data: $MN_PROFISAFE_IN_FILTER is used to define which F net (useful) data
bits of the PROFIsafe modules are accepted for further processing in the SPL.
The filtered F net data bits are pushed together inside the NCK to form a bit array without
any gaps (consecutive bit array).
Machine data: PROFISAFE_IN_ASSIGN is then used to define in which $A_INSE
variables, the filtered F net data bits are transferred.
Example:
Note: For reasons of simplicity, only 16 bits are taken into consideration.
Parameterization:
PROFISAFE_IN_FILTER = A944H
PROFISAFE_IN_ASSIGN = 011006
n = 16 11 6 1
1010 1000 0000 0100
1010 1001 0100 0100
000 0000 0001 1100
xxxx x111 001x xxxx
Max. input limit: –
value at the F net data interface of the
PROFIsafe module
$MN_PROFISAFE_IN_FIL TER
internal NCK F net data image
$INSE[n], x = not relevant
© Siemens AG, 2006. All rights reserved
03.06
Units: –