Input Terminal 3 (ST) Function
Standby
Program Terminal Input Terminals
This parameter is used to set the functionality of the ST
(Standby) discrete input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This parameter sets the programmable ST terminal to one of the
user-selectable functions listed in
Input Terminal 4 (RES) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the RES dis-
crete input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This parameter sets the programmable RES terminal to one of
the user-selectable functions listed in
Input Terminal 5 (S1) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S1 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This parameter sets the programmable S1 terminal to one of the
user-selectable functions listed in
Input Terminal 6 (S2) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S2 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This parameter sets the programmable S2 terminal to one of the
user-selectable functions listed in
88
–
F113
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 9 on page
252.
Table 9 on page
Table 9 on page
252.
Table 9 on page
252.
F117
Direct Access Number —
Parameter Type — Selection List
Factory Default — Standby
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Reset
Changeable During Run — No
252.
Direct Access Number —
Parameter Type — Selection List
Factory Default — Fire Speed
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Preset Speed
2
Changeable During Run — No
https://www.toshiba.com/tic/
F113
F114
F115
F116