Toshiba Q9+ Installation & Operation Manual page 155

Drooping Insensitive Torque
Program Feedback Drooping Control
This parameter defines a torque range in which the Drooping
Control settings will be ignored and the programmed torque set-
tings will be followed.
Drooping Output Filter
Program Feedback Drooping Control
This parameter is used to set the rate of output change allowed
when operating in the Drooping Control mode.
Jerky operation may be reduced by increasing this setting.
https://www.toshiba.com/tic/
–
F323
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F354
Direct Access Number —
Parameter Type — Numerical
Factory Default — 10
Changeable During Run — Yes
Minimum — 0
Maximum — 100
Units — %
Direct Access Number —
Parameter Type — Numerical
Factory Default — 100.0
Changeable During Run — Yes
Minimum — 0.1
Maximum — 200.0
Units — RAD
F323
F324
143