Table of Contents
Advertisement
Figure 35. Complete the virtual linear pump setup.
1. Press the Stop key.
2. The motor decelerates to a stop at the pro-
grammed rate.
3. Click Next to continue (available once reach-
ing zero Hz).
Figure 36. Select an Operating Mode.
1. Select the Virtual Linear Pump operating mode.
2. Select Direct Mode if using no feedback or
select Process Hold if using feedback.
3. Click Save/Exit.
4. While in the Local mode, press Run.
While running, adjust parameters
to stabilize operation if unstable.
https://www.toshiba.com/tic/
F500
and
F501
Virtual Linear Pump Setup
Q9 Plus ASD Install/Op Manual
Press ESC
65
Advertisement
Table of Contents
