Toshiba Q9+ Installation & Operation Manual page 130

RX2 Input Point 1 Frequency
Program Frequency Speed Reference Setpoints
This parameter is used to set the gain and bias of the RX2 input
terminal when the RX2 terminal is used as the control input while
operating in the Speed Control mode.
This parameter sets RX2 Input Point 1 Frequency and is the fre-
quency that is associated with the setting of RX2 Input Point 1
Setting when operating in the Speed Control mode.
See RX2 Input Point 1 Setting (F222) for additional information
on this parameter.
RX2 Input Point 2 Setting
Program Frequency Speed Reference Setpoints
This parameter is used to set the gain and bias of the RX2 input
terminal when the RX2 terminal is used as the control input while
operating in the Speed Control mode or the Torque Control
mode.
This parameter sets the RX2 input level that is associated with
RX2 Input Point 2 Frequency when operating in the Speed con-
trol mode or is associated with the RX2 Input Point 2 Rate when
operating in the Torque Control mode.
This value is entered as -100% to +100% of the RX2 input signal
range.
See RX2 Input Point 1 Setting (F222) for additional information
on this parameter when used for Speed control.
RX2 Input Point 2 Frequency
Program Frequency Speed Reference Setpoints
This parameter is used to set the gain and bias of the RX2 input
terminal when the RX2 terminal is used as the control input while
operating in the Speed Control mode.
This parameter sets RX2 Input Point 2 Frequency and is the fre-
quency that is associated with the setting of RX2 Input Point 2
Setting when operating in the Speed Control mode.
See RX2 Input Point 1 Setting (F222) for additional information
on this parameter.
118
–
F223
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F228
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — +100
Changeable During Run — Yes
Minimum — -100
Maximum — +100
Units — %
Direct Access Number —
Parameter Type — Numerical
Factory Default — (ASD-Depen-
dent)
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
https://www.toshiba.com/tic/
F223
F224
F225