Toshiba Q9+ Installation & Operation Manual page 95

Preset Speed 6
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0110 and is identified as Preset Speed 6. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Preset Speed 7
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0111 and is identified as Preset Speed 7. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
https://www.toshiba.com/tic/
–
F023
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F040
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
F023
F024
83