Toshiba Q9+ Installation & Operation Manual page 102

Input Terminal 10 (LI2) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI2 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI2 termi-
nal to one of the user-selectable functions listed in
page 252.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Input Terminal 11 (LI3) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI3 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI3 termi-
nal to one of the user-selectable functions listed in
page 252.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Input Terminal 12 (LI4) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI4 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI4 termi-
nal to one of the user-selectable functions listed in
page 252.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
90
–
F120
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 9 on
Table 9 on
Table 9 on
F123
Direct Access Number —
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
https://www.toshiba.com/tic/
F120
F121
F122