Table of Contents
Advertisement
IP Master Data 1
Program Communications Ethernet Settings
If using the option board IPE001Z, this parameter is used in con-
junction with parameters
Parameters
F589
–
F592
the Master ASD in managing transfers to and from the Slave ASD
in a Master-Slave ASD network relationship.
IP Master Data 1
IP Master Data 2
IP Master Data 2
Program Communications Ethernet Settings
See
F589
for information on this parameter.
IP Master Data 3
Program Communications Ethernet Settings
See
F589
for information on this parameter.
IP Master Data 4
Program Communications Ethernet Settings
See
F589
for information on this parameter.
I/O Scan Permission
Program Communications Ethernet Settings
This parameter Enables/Disables the ability of the system to read
the terminal settings of the Terminal Board (i.e., F, R, OUT1, FP,
etc.).
Settings:
0 — Prohibit
1 — Permit
https://www.toshiba.com/tic/
–
F589
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F589
–
F592
to configure the network.
identify locations that may be used by
IP Master Data 3 IP Master Data 4
F594
Direct Access Number —
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Direct Access Number —
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Direct Access Number —
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Direct Access Number —
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Direct Access Number —
Parameter Type — Selection List
Factory Default — Prohibit
Changeable During Run — Yes
F589
F590
F591
F592
F593
181
Advertisement
Table of Contents
