Toshiba Q9+ Installation & Operation Manual page 181

RX2 Input Gain
Program Frequency  Speed Reference Setpoints
This parameter is used to fine-tune the gain of the RX2 (AI1
Option) input terminal when this terminal is used as the control
input while operating in the Speed Control mode or the Torque
Control mode.
This setting may be used to ensure that the 100% level of the
input source (pot, pressure transducer, flow meter, etc.) is also
the 100% level setting of the ASD system.
This is accomplished by setting the input source to 100% and
adjusting this setting to provide an output of 100% from the ASD.
Option V/I Input Bias
Program Frequency  Speed Reference Setpoints
This parameter is used to fine-tune the gain of the Optional AI2
input terminal when this terminal is used as the control input
while operating in the Speed Control mode or the Torque Control
mode.
This setting may be used to ensure that the 100% level of the
input source (pot, pressure transducer, flow meter, etc.) is also
the 100% level setting of the ASD system.
This is accomplished by setting the input source to 100% and
adjusting this setting to provide an output of 100% from the ASD.
Option V/I Input Gain
Program Frequency  Speed Reference Setpoints
This parameter is used to fine-tune the gain of the Optional AI2
input terminal when this terminal is used as the control input
while operating in the Speed Control mode or the Torque Control
mode.
This setting may be used to ensure that the 100% level of the
input source (pot, pressure transducer, flow meter, etc.) is also
the 100% level setting of the ASD system.
This is accomplished by setting the input source to 100% and
adjusting this setting to provide an output of 100% from the ASD.
https://www.toshiba.com/tic/
–
F477
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F480
Direct Access Number —
Parameter Type — Numerical
Factory Default — 128
Changeable During Run — Yes
Minimum — 0
Maximum — 255
Direct Access Number —
Parameter Type — Numerical
Factory Default — 128
Changeable During Run — Yes
Minimum — 0
Maximum — 255
Direct Access Number —
Parameter Type — Numerical
Factory Default — 128
Changeable During Run — Yes
Minimum — 0
Maximum — 255
F477
F478
F479
169