Toshiba Q9+ Installation & Operation Manual page 218

Free Unit
Program Utilities Display Parameters
This parameter is used in conjunction with
method in which the frequency is displayed on the EOI.
The multiplier setting of
frequencies if all frequencies are selected at this parameter.
The multiplier setting of
F365, F367, and F368 ONLY if PID Process Data is selected at
this parameter.
Settings:
0 — All Frequencies
1 — PID Process Data
Free Unit Display Gradient Characteristic
Program Utilities Display Parameters
The ASD-displayed response to output speed changes will be
displayed as directly proportional or inversely proportional as a
function of this parameter setting.
Selecting Negative Gradient displays an increased output speed
as going more negative.
Selecting Positive Gradient displays an increased output speed
as going more positive.
Settings:
0 — Minus (Negative Gradient)
1 — Plus (Positive Gradient)
Free Unit Display Bias
Program Utilities Display Parameters
In conjunction with the setting of F702, this parameter sets the
bias of the EOI speed display.
The frequency entered here will be multiplied by the setting of
F702 and then displayed as the zero value on the EOI display.
Change Step Selection 1
Program Utilities Display Parameters
In conjunction with the parameter setting of
sets the amount that the output speed will increase or decrease
for each speed command change entered from the EOI using the
Rotary Encoder.
206
–
F703
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F702 to set the
F702 will be applied to the display of all
F702 will be applied to parameters F364,
F708, this parameter
F708
Direct Access Number —
Parameter Type — Selection List
Factory Default — All Frequen-
cies
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Selection List
Factory Default — Plus
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
https://www.toshiba.com/tic/
F703
F705
F706
F707