Toshiba Q9+ Installation & Operation Manual page 34

Electronic Operator Interface
Q9 Plus ASD Install/Op Manual
Figure 21. The Q9
Plus ASD Electronic
Interface Features.
LED/LCD
Display Unit
EOI
LED Screen
LCD Screen
Remove the
screw first to remove the
LED/LCD display unit to
activate the
Backup system.
functions of the displayed menu selection. Press
the Rotary Encoder to perform the Enter (select)
function.
Local/Remote Key — Toggles the system to and
from the Local and Remote modes. The LED is on
when the system is in the Local Command mode.
The Local mode allows the Command and
Frequency control functions to be carried out via the
EOI.
The Remote mode enables the Command and
Frequency control functions to be carried out via the
Terminal Board, RS485, Communication Card, or
Pulse Input. The selection may be made via
Program  Fundamental Standard Mode
Command Mode
Selection
1, respectively.
Note: See the section titled
Frequency Mode Control on pg. 33
information on system control.
ESC Key — Returns the system to the previous
level of the menu tree, toggles between the EOI
Command screen and the Frequency Command
screen, or cancels changes made to a field if
pressed while still in the reverse video mode (dark
22
Phillips
Battery
and Frequency Mode
Command Mode and
for more
background/light text). The three functions are
menu-specific.
Run Key — Issues the Run command while in the
Local mode. The Run key LED illuminates green
while stopped and red while running or exciting the
motor.
Mode Key — Provides a means to access the root
menus. Pressing the Mode Key repeatedly loops
the system through the root menus (see
on pg. 36). While looping through the root menus,
the Program menu will display the default Program
root menu screen item or the Program sub-menu
item being accessed prior to pressing the Mode key.
Stop-Reset Key — This key has three functions.
1. Issues the Off command (decelerates to Stop at
the programmed rate) if pressed once while in
the Local mode.
2. Initiates an Emergency Off command if pressed
twice quickly from the Local or Remote modes.
The Emergency Off function terminates the Q9
Plus ASD output and will apply the stopping
method selected at F603.
3. Resets active Faults and/or active Alarms if
pressed twice quickly. The source of the Fault
or Alarm must be determined and corrected
before normal ASD operation can resume.
https://www.toshiba.com/tic/
Rotary Encoder
Local/Remote Key
(LED)
Escape Key
Run Key (LED)
Mode Key
Stop/Reset Key
Figure 29.