Mitsubishi Electric SV13/22 Programming Manual page 213

7. POSITIONING CONTROL
[Cautions]
Downloaded from ManualsNet.com
(3) Stop commands and stop processing
The stop commands and stop processing for speed control are listed in Figure
7.1.
Stop Command
External STOP signal
Stop command
(M1800+20n)
Rapid stop
(Note)
command
(M1801+20n)
Emergency stop from
(Note)
peripheral device
(test mode)
Speed changed to 0
POINT
(Note): The rapid stop command and emergency stop from a peripheral
device are valid during deceleration due to input of an external STOP
signal or the stop command (M1800+20n), and processing according
to the rapid stop deceleration time parameter starts at the time the
stop condition occurs.
Speed limit value
(1) After running speed control using the absolute data system, the feed present
value cannot be set to zero by the following operations:
• Reset with the RUN key
• Turning on the servo power supply (OFF → ON)
(2) The dwell time cannot be set.
search engine
Fig. 7.1 Stop Commands and Stop Processing
Stop
Stopped Axis
Condition
Designated
OFF → ON
axis
Key input All axes
Value stored in
speed change Designated
register axis
Operation speed
STOP signal or stop command
from external source
Rapid stop command or emergency
stop signal from peripheral device
7 − 61
Stop Processing
Deceleration stop according to the
deceleration time on STOP input
designated in the parameter block or by
a servo instruction.
Deceleration stop according to the
deceleration time designated in the
parameter block or by a servo
instruction.
Deceleration stop according to the rapid
stop deceleration time designated in the
parameter block or by a servo
instruction.
Deceleration stop according to the rapid
stop deceleration time designated in the
parameter block or by a servo
instruction.
Deceleration stop according to the
deceleration time designated in the
parameter block or by a servo
instruction.