Speed Control (Ii) - Mitsubishi Electric SV13/22 Programming Manual

7. POSITIONING CONTROL
7.13

Speed Control (II)

Servo
Instruction
VVF
VVR
[Control Details]
[Cautions]
Downloaded from ManualsNet.com
(1) Speed control of the axes designated in the sequence program positioning
commands.
(2) Control does not include positioning loops for control of servo amplifiers.
Use stopper control to prevent errors becoming excessive.
(3) Speed control (II) uses the VVF (forward) and VVR (reverse) servo instructions.
Number of
Positioning
Controllable
Method
Axes
 ∆
!
1
(1) Controls the axis at the designated speed between the start of servomotor
operation and the input of the stop command.
• VVF .......movement in forward direction
• VVR.......movement in reverse direction
(2) The current value or deviation counter do not change at zero.
(3) When the setting for "torque" is set in a servo program and an indirect
designation is made, the torque limit value can be changed during operation by
changing the value of the indirect device.
(4) The stop command and stop processing are the same as for speed control(I).
(1) After running speed control using the absolute data system, the feed current
value cannot be set to zero by resetting with the RUN key.
(2) The dwell time cannot be set.
search engine
Items Set by Peripherals
Common Arc
∆ ∆
!
7 − 64
Parameter Block
∆ ∆ ∆ ∆ ∆ ∆ ∆
Others
∆ ∆
OK
! : Must be set
∆ : Set if required