Mitsubishi Electric SV13/22 Programming Manual page 309

8. AUXILIARY AND APPLIED FUNCTIONS
The speed limit value, acceleration time, and deceleration time are data from the designated parameter block.
Downloaded from ManualsNet.com
The relationship between the commanded speed (positioning speed set in the
servo program) and actual speed (actual positioning speed) is shown below for
different electronic gear settings.
• if electronic gear setting = 1, commanded speed = actual speed
• if electronic gear setting < 1, commanded speed < actual speed
• if electronic gear setting > 1, commanded speed > actual speed
Speed limit
value
Commanded
speed
Actual
acceleration
time
Set acceleration time
Figure 8.3 Relationship Between Commanded Speed and Actual Speed
search engine
V
2)
1)
3)
Set deceleration time
8 − 11
1) electronic gear setting = 1
2) electronic gear setting < 1
3) electronic gear setting > 1
t
Actual
deceleration
time