Panasonic LP-RF Series Setup & Maintenance Manual page 181

3.
Loosen the screws (two locations) on the cover panel of the battery inside the controller and remove the cover.
• Before the maintenance work, always discharge the static electricity by touching the grounded metal objects, etc. Static
electricity can damage electrical components inside controller.
• Do not touch any other devices on the circuit board.
4.
Remove the connector for the battery inside the controller (coin-type).
Attach the connector to the new battery.
• If you wish to dispose used batteries, please comply with its regional regulation. For
the correct method of disposal, please contact your local municipality, waste disposal
services, or the point of sale where you purchased the batteries.
5.
Tighten the screws (two locations) on the cover panel of the battery inside the controller and install the cover.
Tightening torque: 0.5 N·m
6.
Insert the side panel straight. The projecting part of upper and bottom of the side panel should be fit the drain of the
controller. Slide the panel to the front of the controller and tighten the screws (M3 screws, four positions) of the back of
the controller.
Tightening torque: 0.5 N·m
• Be careful not to let the inside cables get caught while installing.
ME-LPRF-SM-11
181