Panasonic LP-RF Series Setup & Maintenance Manual page 95

No. Name and description
19 to 21 SELECT 0 IN to SELECT 2 IN
With SELECT 0 IN to SELECT 2 IN, the setting target of D0 IN to D15 IN and Guide laser indication target
are specified.
• Select the setting target of D0 IN to D15 IN
Specify SELECT 0 IN to SELECT 2 IN corresponding to the setting target shown below. Keeping the input
of SELECT 0 IN to SELECT 2 IN and D0 IN to D15 IN (No.3 to 18), turn ON SET IN (No.2).
Setting target of D0 IN to D15 IN
File No.
Count up value correction
Count down value correction
Counter number to reset
Data number of registered characters/
external offset
• Select guide laser indication target
Specify SELECT 0 IN to SELECT 2 IN corresponding to the indication target of guide laser as shown
below. Keeping the input of SELECT 0 IN to SELECT 2 IN, turn ON GUIDE IN (No.23).
Indication by guide laser
Work distance
Marking image
Marking field
Masked objects
22 TIME HOLD IN: Time/date hold input
Performs marking of date and lot, reflecting the time when the input is turned ON.
While this input is turned on, the laser marker retains the time and date of the system clock at the point when
the input was turned ON, then it marks the functional characters for current date, expiry date, and lot.
TIME HOLD IN is available even when the remote mode is turned off.
If TIME HOLD IN is turned ON when powering on the laser marker, it retains the system startup time.
23
GUIDE IN: Guide laser radiation input
The guide laser irradiates while the input is turned ON. (Up to one minute)
Determine the guide laser radiation details by the combination of SELECT 0 IN to SELECT 2 IN (No.19 to
No.21). Keep the input state of SELECT 0 IN to SELECT 2 IN while GUIDE IN is turned ON.
This terminal is available when the guide laser control method is set to I/O at the system settings of Laser
Marker NAVI smart.
Input this terminal with the shutter closed.
24 TIMING IN
This is the terminal you will use when the link control function with the image checker is configured.
Turn this terminal ON when you instruct the operation timing to the laser marker or to the target device
controlled by the link function. Starts the link control processing by edge of input ON.
Input this terminal within 60 seconds from turning ON of TIMING WAIT OUT (No.36).
For details, refer to "6-1 Link Control with Image Checker" (P.136).
25, 26 RESERVE: System reservation
Do not connect externally.
SELECT 0 IN SELECT 1 IN
OFF
OFF
ON
OFF
ON
SELECT 0 IN SELECT 1 IN
OFF OFF
ON OFF
OFF ON
ON ON
ME-LPRF-SM-11
SELECT 2 IN
OFF OFF
ON OFF
ON OFF
OFF ON
OFF OFF
SELECT 2 IN
OFF
OFF
OFF
OFF
95