Panasonic LP-RF Series Setup & Maintenance Manual page 30

4. Frame ground terminal: F.G.
This is the terminal for ground. Ground this terminal to the earth permanently.
5. Laser emission port
The emission port of the marking laser and the guide laser.
6. Protection glass of laser emission port
This glass protects laser emission port from dirt or damage.
Attach this glass always. Remove the plastic cap on this glass before operation.
7. Laser pointer emission port
From this port the red laser pointer radiates in oblique direction when using the work distance indication of the guide
laser. Refer to "2-3-4 Marking position check" (P.41).
To use the guide laser, do not seal the laser pointer emission port at the installation.
8. Fiber unit
Connection part for the laser transmission from the controller to the head.
The fiber unit can be detached from the head. Refer to "2-3-5 Detaching / attaching the fiber unit" (P.42).
9. Fiber cable
Laser transmission cable from the controller to the head. This cable cannot be detached from the fiber unit.
10. Heat sink
Fin for promoting heat radiation.
30
ME-LPRF-SM-11