Panasonic LP-RF Series Setup & Maintenance Manual page 198

Troubles
The sending
command is not
accepted and
negative response is
returned.
* These commands are applicable with the standard command mode. For the LP-400/V compatible mode, refer to the "Serial
Communication Command Guide: LP-400/V compatible mode".
198
Causes
Two or more command data
are transmitted at the same
time.
Command mode (LP-400/V
compatibility setting) is wrong.
The character code is wrong.
After sending the command, confirm the response data from the
laser marker. Do not send the next command before receiving
the response.
• If you want to use the same command format with the
former models of LP-400/LP-V series, enable "LP-400/V
compatibility" in system settings of Laser Marker NAVI smart.
• If you want to use the standard command format, switch the
mode by RSM command or disable "LP-400/V compatibility"
in system settings of Laser Marker NAVI smart.
• Check the setting for "Encoding for non-ASCII characters" in
the "System settings".
• Check if characters in the readout strings can be encoded with
ASCII code or the character code specified in "Encoding for
non-ASCII characters".
• "Shift JIS", "GB 2312" and "Latin-1" cannot be used together.
• In LP-400/V compatible mode, only ASCII code and Shift JIS
are available.
ME-LPRF-SM-11
Measures