Panasonic LP-RF Series Setup & Maintenance Manual page 44

„ Procedure for fiber unit attaching
1.
Remove the scanner unit protection cover.
Keep the scanner unit protection cover for the next use.
2.
Make sure that the O-ring is attached to the joint part
of the fiber unit properly.
• If there are signs of deterioration or damage in the O-ring, replace it. Replacement O-ring (Set of connector cover and
gasket: LP-ACC10) is available on request. For purchasing it, contact our sales agency.
3.
Make sure that the fiber cable is not twisted.
If a plastic bag or other protection cover is attached to the fiber unit, remove it.
• If the fiber cable is twisted, it may cause of a power decrease or a failure.
44
ME-LPRF-SM-11
Scanner unit protection cover
O-ring